Страница 2 из 2

Re: area doesn't fill correctly

Добавлено: 17 окт 2014, 10:23
Nick
narvf писал(а):In tecroids image for exmaple path goes down, right, up, right, down, right and so on except for letters so on.
May be it's Spiral vs Zig-Zag option?

Re: area doesn't fill correctly

Добавлено: 22 окт 2014, 22:15
tecdroid
hi,
i just played around a bit and i think i've found some good working configuration.
However, I've got some questions.
Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
Next, I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?

Re: area doesn't fill correctly

Добавлено: 28 окт 2014, 11:44
Nick
tecdroid писал(а):Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
There should be angle parameter which defines zig-zag "orientation"
tecdroid писал(а): I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?
What does that mean?

Re: area doesn't fill correctly

Добавлено: 13 ноя 2014, 00:21
tecdroid
When engraving an area the machine runs a straight line, goes up to safe z, goes down, runs next line and so on..
i'd like it to engrave the whole area and only going to safe position when neccessary..

Re: area doesn't fill correctly

Добавлено: 13 ноя 2014, 02:00
narvf
I think it's actually not possible :/

Re: area doesn't fill correctly

Добавлено: 14 ноя 2014, 12:28
tecdroid
well, should be since it saves much time..